We manufacture state of the art technology Rectifiers used for Plating, Anodising & Hydrogenation applications. The Rectifier consists of three parts
1) Double wound Transformer.
2) Linear Rolling contacts type Regulators.
3) Silicon Diode Cubicle.
4) Superior Features of our DC Rectifiers.
It will be designed such that it will take up/absorb the Spike/Surges produced in the system, which no other manufacturer is giving. The spike which being of very high voltage persists for milisec if passed on to the system, will result into damage/burnt of all the electrical/electronic devices connected with it results in heavy loss.
Our Rectifier will be suitable for 100% load for continuous duty cycle and recommended to put 10% over load also.
The efficiency of our Transformer used in the Rectifier will be more than 95%.
The Ripple contents of our Rectifier will not be more than 5% of the value while in other manufacturers case, the Ripple contents are always higher even more than 10% by which the output DC voltage will not be pure and will not perform efficiently.
We Design our Rectifiers in such a way that their Temperature Rise should not increase above 25-27 degree Centigrade above Ambient at 100% load results in Higher Efficiency and lesser losses while in others case, they design their Rectifier with 45 degree Centigrade Temp. rise above ambient.
We always use IPT Transformers in our Rectifiers, which further reduces the Losses of the system while any other manufacturer is not using the same.
|
